Cable Trunking Drawings and Fittings

Cable Trunking and Fittings from Our Shop

Cable Trunking Drawings

Important ordering notes:

1. Type 1 is the standard production pattern.
2. Types 2, 3 and 4 are manufactured on request. Please specify the required pattern when ordering.

Straight Cable Trunking Section

Connectors and Splice-Hole Patterns

Splice Plate (Default)

Cable trunking connector: Type 1 splice holes – configuration depends on height

Cable trunking connector: Type 2 splice holes – configuration depends on height

Cable trunking connector: Type 3 splice holes – configuration depends on height and project requirements

U-Connector (On Request)

Cable trunking splice holes, Type 1 (depending on height)

Cable trunking splice holes, Type 2 (depending on height)

Cable trunking splice holes, Type 3 (depending on height and customer requirements)

Cable Trunking Fitting Drawings

Product Code Guide

Straight Cable Trunking Ordering Code

Product code: MC-WxHxT-N-LN-XXX

Where:

• W: Width (mm)

• H: Height (mm)

• T: Thickness (mm)

• N= CN: With cover

• N= KN: Without cover

• N= ND: Cover only (without body)

• LN= LN1: Type 1 splice holes (see the patterns below)

• LN= LN2: Type 2 splice holes

• LN= LN3: Type 3 splice holes

• XXX= STD : Powder-coated steel

• XXX= TTK : Pre-galvanized steel

• XXX= KNN : Hot-dip galvanized steel

• XXX= INO : Stainless steel 304

• XXX= HKN : Aluminium alloy

Examples:

1. MC-200x100x1.2-CN-LN1-STD : Cable trunking 200 mm wide × 100 mm high × 1.2 mm thick, with cover, Type 1 splice holes, powder-coated steel.

2. MC-100x50x0.8-KN-LN2-INO: Cable trunking 100 mm wide × 50 mm high × 0.8 mm thick, without cover, Type 2 splice holes, stainless steel 304.

Fitting Ordering Code

Fitting code: MC-PK-WxHxTxR-N-LN-XXX

Where:

• PK= CN: Horizontal bend

• PK= CL: Inside vertical bend

• PK= CX: Outside vertical bend

• PK= TE: Tee

• PK= TH: Cross

• PK= GD: Symmetrical reducer

• PK= GT: Left-Hand Reducer

• PK= GP: Right-hand reducer

• W: Width (mm)

• H: Height (mm)

• T: Thickness (mm)

• R: Custom bend radius. If R is omitted, The Sun’s standard bend radius applies.

• N= CN: With cover

• N= KN: Without cover

• N= ND: Cover only (without body)

• LN= LN1: Type 1 splice holes (see the patterns above)

• LN= LN2: Type 2 splice holes

• LN= LN3: Type 3 splice holes

• XXX= STD : Powder-coated steel

• XXX= TTK : Pre-galvanized steel

• XXX= KNN : Hot-dip galvanized steel

• XXX= INO : Stainless steel 304

• XXX= HKN : Aluminium alloy

#cabletrunking #electricaltrunking #cablemanagement #cabletrunkingdrawings #cablefittings